Laying tiles in the bathroom: up to what height to tile? Tiles on the bathroom wall work well in all those places that are flooded or splashed with water: above the bathtub, in the shower, behind the sink. And it is enough to attach them only there. We advise the height of tiles in the bathroom.
Tiles on the bathroom wall do not have to occupy the entire surface of the bathroom, sometimes it is enough if the tiles in the bathroom are only laid in places prone to splashing and getting wet. The height of the glazing – what you need to remember. Well-arranged tiles will protect the wall and will be a decorative element. We advise you to what height to lay the bathroom tiles.
Laying tiles: important decisions
Choosing the type of bathroom tiles and how to arrange them should not be put off until the last minute. Planning the finish already at the construction stage allows you to choose the best materials and avoid unnecessary problems when arranging the bathroom. Tiling works are a tedious and long-lasting job. Laying tiles requires accuracy and careful preparation. It is not enough to vacuum the substrate and simply stick the tiles. The need to arrange patterns, cut elements and finish all contacts means that the first thing to do is to design the arrangement of tiles on the floors or walls in the bathroom, so select the appropriate type, size, pattern, measure straight surfaces and places of planned cuts, determine the way of finishing the contacts. The type of materials used for installation and the way of carrying out the work related to laying bathroom tiles depend on it.
Laying tiles should always start from the most exposed place. If it is a corner of the room, the tiles on the floor as well as on the walls should be trimmed as completely or evenly as possible, and the joints carefully finished. If the attention is not focused in a specific place, but on a larger area, you need to take care of its harmonious appearance or consciously insert a strong decorative accent that will catch the eye. Regardless of the solution used, in order for the cladding to look nice, appropriate, undamaged tools must be used for cutting and grinding the elements, and holes for sockets or pipe penetrations should be made with hole saws.
How to put tiles in the bathroom
The bathroom is constantly exposed to the direct action of water, steam and a high concentration of moisture, which makes it easy for microorganisms to develop in it. They always choose the most absorbent surfaces, in which moisture remains for a long time, i.e. joints and corners. Along with the corners, silicone is used instead of the joint. It should also be resistant to microorganisms, that is, sanitary. It is also important to properly protect the substrate against water, for example with liquid foil. Sealing can cover all surfaces, but it is not necessary. However, it must always be on the floor and extended 15 cm to the walls. In the vicinity of the bathtub and shower, the tiles should extend at least 20 cm above the water coverage area.
Tiles on the wall in the bathroom: how to lay in the cabin
A typical shower cubicle is 200 cm high. Tiles on the wall in the cabin must be laid up to its upper edge. But if there is a bathtub or a washbasin next to it, even though there is no such need, tiles in these places can also be laid up to a height of 2 meters. Then the interior architecture will be consistent.
Tiles on the wall in the bathroom: stacking to the height of the sink
If there is no shower cubicle in the bathroom or the shower is separated behind the wall, the height of the tiles may be determined by the washbasin. The tiles arranged in this way will then constitute a kind of panelling, almost 120 cm high. And if the colour of the tiles and the walls above them are contrasting, it is worth knowing that the horizontal division of the wall slightly below half of the height will visually raise the interior
, and a little higher – will lower it.